READ ENTIRE LABEL BEFORE APPLYING
DESCRIPTION AND USES
RockSolid® Crack & Patch is a fast setting, general purpose cement-based patching material for repairing concrete and masonry. Crack & Patch can be used to enhance the appearance of most concrete surfaces. Crack & Patch can be applied from a feather-edge up to ½” thick to repair horizontal, vertical and overhead applications. It can be applied to concrete floors to level low spots before applying floor coverings such as wood or tile.
Primary applications include driveways, walkways, stairs, patios, pool decks, basement floors and garage floors.
PRODUCT FEATURES
- For repairs not greater than ½ inch
- Just add water to create a workable, easy to apply mixture
- Smooth creamy consistency
- Low shrinkage
- Trowel or float spread to a smooth coat
- Fast setting in 8-10 minutes
- Fix concrete blemishes
- Repair spalling and salt damage
- Can be shaped, molded and shaved down to help form applications
- Use to fill honey-comb or bug holes
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
All surfaces must be structurally sound and non-flexing. Prepare the surface by removing all dust, waxes, sealers, old adhesive residue, curing compounds, oil or other foreign materials prior to the application. Dampen the area with clean water prior to the application. Do not leave puddles or standing water.
MIXING
Tear bag open by the notches on the sides. Add 1¼ cups (10 ounces) of clean water per 3 pound bag. You may add up to ¾ cup (6 ounces) of additional clean water if needed. Squeeze the pouch to remove excess air. Zip the pouch closed and knead the bag for about 3 minutes until a lump free consistency is achieved. If necessary, mix in a secondary container. Product will set in 8-10 minutes, so mix only amount needed.
APPLICATION
Crack & Patch is suitable for application at temperatures between 50° (10°C) and 100°F (38°C). Crack & Patch can be applied up to ½” thickness to repair horizontal, vertical or overhead concrete. Dampen or mist the area to be repaired. Force the material into the area with a trowel or by hand to secure a complete bond over the entire area to be repaired. Always slightly overfill the target repair area with Crack & Patch. Allow the material to set for approximately 8-10 minutes; then shave the material to follow the shape of the surrounding surface. Always shave toward the common bonding line between the repair mortar and the existing surface.
THINNING
Not required.
CLEAN-UP
Clean tools and equipment with water immediately after use. If the material has begun to harden, clean with warm soapy water.
KEEP OUT OF REACH OF CHILDREN AND ANIMALS. DO NOT TAKE INTERNALLY.