DESCRIPTION AND USES
Watco Danish Oil is a unique blend of penetrating oil & varnish, which hardens in the wood, not on the wood. Watco Danish Oil penetrates deep into wood pores to protect from within and to enhance the natural look and feel of the wood. It creates the rich, warm glow of a traditional hand-rubbed finish. Many projects can be completed in less than an hour - simply brush or wipe on and wipe off.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
Remove any existing finishes with sandpaper or stripper. Prepare bare wood for finishing by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress though #150, #180 and #220 grits. Before applying Watco Danish Oil, remove all sanding dust and dirt with a vacuum, tack cloth, or rag dampened with mineral spirits. For grease and glue, remove with a rag dampened with mineral spirits.
TESTING COLOR
Be sure to test your stain to verify the desired color. To test, apply the stain in an inconspicuous area.
OPTIONAL STEPS
Pre-treat soft woods, such as pine, by lightly wiping the wood surface with a cloth moistened with Watco Danish Oil Natural finish. Immediately wipe the surface completely dry and proceed with application.
APPLICATION
Use only when air (ambient) temperature is between 60- 90°F (16-32°C) and relative humidity is below 85%. Allow for longer dry times during damp and humid conditions. Mix or shake material thoroughly to ensure that any settled pigment is re-dispersed before application. Stir occasionally during use. Apply a test sample on a small inconspicuous area before proceeding with the entire job. Apply one coat of Watco Danish Oil liberally with a brush or clean lint free rag. Allow to penetrate for 15 minutes then remove excess by wiping with a rag in the direction of the grain. If additional coats are needed, reapply allowing an additional 15 minutes penetration. Wipe surface completely dry. Removal of all excess material is essential to ensure proper dry time and proper adhesion of topcoat.
ADDITIONAL PROTECTION
For additional protection, any Rust-Oleum® polyurethane finish can be applied over the Watco Danish Oil. Allow a minimum of 72 hours dry time prior to applying the polyurethane finish. Darker colors may require slightly longer dry time.
MAINTENANCE
Apply fresh coats as needed to repair surface scratches and to remove minor stains. Burnish affected area with fine steel wool or #220-grit sandpaper, then apply the Watco Danish Oil color originally used to finish the wood.
CLEAN UP
Application tools or brushes should be cleaned with mineral spirits or paint thinner.
DISPOSAL
Warning! Rags, brushes, or other waste soaked with this product may spontaneously catch fire if improperly discarded. Immediately after use, place rags or waste in a sealed, water-filled metal container. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal regulations.