DESCRIPTION AND USES
Rust-Oleum Stops Rust Custom Spray 5-in-1 allows you to choose between 5 different spray patterns for ultimate control and confidence over your next project. Stops Rust Clear Protective Enamel is the ultimate standard in rust protection and durability while providing an ultra glossy or matte finish. The advanced Stops Rust Clear Enamel formula provide 30% greater protection when compared to original matching Stops Rust Clear Enamels with standard tip based on ASTM tests for adhesion over steel (ASTM D3359), Mandrel Bend/flexibility (ASTM D522) and impact resistance (ASTM D2794). The advanced Stops Rust Clear Enamel formula also provide 30% greater color retention when compared to original matching Stops Rust Clear Enamels with standard tip (ASTM D2244).
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces. Clean with soap and water, rinse and let dry.
APPLICATION
Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy, dusty conditions. Cover surrounding area to protect from spray mist.
Before spraying, turn dial to the desired spray pattern and test on an inconspicuous area or on scrap material. Scan QR code to learn more. Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Keep the can the same distance from the surface. Recommended distance from the surface will vary based on spray selection. Scan QR code on can for details. Keep the can in motion while spraying. Spray in a steady back-and-forth motion, slightly overlapping each stroke. Spray at any angle. Apply 2 or more light coats a few minutes apart. Turn dial to LOCK position when finished spraying.
Dial Position Spray Description Recommend Spray Distance
1 High Output 10-14”
2 Standard 8-12”
3 Low Output 3-6”
4 Vertical Fan 8-12”
5 Horizontal Fan 8-12”
DRY AND RECOAT TIMES
Based on 70°F (21°C) 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 15 minutes, to handle in 30 minutes. May recoat anytime. Do not apply clear over Stops Rust® Bright Coat Finish or Aluminum Finish.
DIAL CARE AND CLOGGING
To prevent clogging, clean face of the dial with mineral spirits when finished spraying. DO NOT remove cap or dial.
CLEAN UP
To remove wet paint, clean with mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor.