DESCRIPTION AND USES
Rust-Oleum Anti-Slip Floor Spray creates a barefoot-friendly, textured finish that adds traction to prevent slipping in high foot traffic areas such as floors, walkways and steps. This clear, fast-drying formula resists peeling and fading and protects the surface from stains, impact, scratches, and weather.
For use on interior or exterior, coated concrete or wood surfaces including garage floors, porches, patios, decks, walkways and steps. Before applying to any surface or coating, always test in a small, inconspicuous area for adhesion and appearance.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
For Previously Coated Concrete or Wood: Clean surface to remove grease, oil, salt and other contaminants with Rust-Oleum Heavy Duty Degreaser or Rust-Oleum Cleaner & Degreaser (sold separately). Follow instructions as noted on the product label and ensure the surface is completely dry.
For Freshly Painted Concrete or Wood: Allow a minimum of 24 hours dry time before applying the Anti-Slip Floor Spray. Remove any debris before spraying. Apply over coatings such as Rust-Oleum, EpoxyShield®, RockSolid® Garage Coatings or Rust-Oleum Porch, Floor and Patio Coating.
APPLICATION CONDITIONS
Use in a well-ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Avoid spraying in very windy, dusty conditions. Mask off areas and objects to protect from overspray.
APPLICATION
Shake can vigorously for one minute after mixing ball begins to rattle. If the mixing ball fails to rattle DO NOT STRIKE. Contact Rust-Oleum. Shake often during use. Hold can upright 10-12” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Remove any overspray immediately. If a second coat is desired, wait 1-2 minutes before applying the second coat.
DRY & RECOAT
Dry and recoat times are based on 70°F (20°C) and 50% relative humidity. Allow more time at cooler temperatures. Air dry for a minimum of one hour. Surface can be recoated at any time. Allow 72 hours for full cure. Reapply as needed.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean up wet or dry coating with Xylene. Mineral spirits can also be used to remove wet paint. Throw away empty can in trash pickup. Do not burn or place in home trash compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a solvent such as Xylene. Do not stick a pin or other object into the stem.