DESCRIPTION AND USES
Rust-Oleum Stops Rust Satin Clear Enamel is an excellent protective clear coating that resists corrosion, tarnishing and chipping.
Stops Rust Satin Clear Enamel features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PRODUCT APPLICATION
READ ALL DIRECTIONS BEFORE BEGINNING PROJECT
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50 and 90°F (10 and 32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and let dry. Remove loose paint and rust with a wire brush or sandpaper. Clean concrete surfaces with a suitable cleaner and water. Rinse and allow to dry. Lightly sand glossy surfaces.
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. For best results, apply multiple light coats versus applying one heavy coat. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 15 minutes, to handle in 30 minutes. May recoat at anytime. Do not apply Clear Enamel over Stops Rust Bright Coat Finish or Aluminum Finish.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.