DESCRIPTION AND USES
Krud Kutter Multi-Purpose Pressure Washer Concentrate is a ready to use, commercial strength formula recommended for all exterior siding (wood, vinyl, aluminum), roofing of all types (asphalt shingles, fiberglass shingles, cedar, tile), gutters, stucco, brick and cement block, masonry, concrete driveways, walkways and walls, porch screens, pool areas, engines and equipment, even RV’s, patio furniture and boats.
PRODUCT APPLICATION
DIRECTIONS
IMPORTANT – READ ENTIRE LABEL BEFORE USE
- When using a pressure washer to clean painted surfaces, please be aware that water pressure alone may remove paint, or highlight existing discoloration caused by the sun's UV rays.
- From the garden hose, rinse any nearby plants with clean water.
- Always test on an inconspicuous area first.
- Any overspray can be neutralized with large volumes of water.
- For heavy oil and grease stains (such as on driveways and garage floors), pour product directly onto the stain. Allow to penetrate for 5 to 10 minutes; then follow normal application procedures.
- In case of severe oil and grease stains on porous surfaces, oil may bleed to the surface or leave a residual stain. Repeat applications may lighten stains, but not remove completely.
- Do not mix this product with any other chemicals.
COVERAGE
When mixed 1:10 (12 oz. of concentrate with 1-gallon of water), one bottle of concentrate will make 11 gallons of premix, and clean up to 3,200 sq. ft.
NO SCRUBBING – SPRAY ON•WASH OFF
No scrubbing, simply apply to the surface, leave for 3 to 5 minutes, and wash off. Contains anti-corrosive agents to safeguard pressure washer parts (bleach can erode O-rings). Penetrates and helps remove tough stains from dirt, oil, grease, bird droppings, tree sap, mold and mildew.
DIRECTIONS: PRESSURE WASHER APPLICATION
Rinse surrounding plants with water, before and after application. Wet surface to be cleaned, prior to applying the product. Place detergent application siphon tube and screen filter directly into container. Open meter valve (if applicable) for maximum product flow. For reservoir machines, pour product (full strength) into pressure washer. Spray at low pressure onto a wet surface. On vertical surfaces, always spray from the top down. Allow product to remain on the surface for 3 to 5 minutes to penetrate. Do not allow product to dry on surface. Remove siphon tube from solution and rinse surface with high-pressure spray thoroughly. Flush siphon tube with clean water prior to storage.
NOTE: For use in a pump up sprayer, mix 12 oz. of concentrate with 1-gallon of water.
NO BLEACH OR AMMONIA. SAFE FOR PEOPLE, PETS AND PLANTS.
CAUTION! EYE AND SKIN IRRITANT. This product contains alkaline detergents. Do not take internally. In case of contact with eyes or skin, flush with water for at least 15 minutes. If irritation persists, seek medical attention. If swallowed, take large amounts of water. Do not induce vomiting. Get medical attention.
KEEP OUT OF REACH OF CHILDREN.