DESCRIPTION AND USES
Rust-Oleum Stops Rust Automobile Primer provides a durable rust-inhibitive base for most automotive lacquers and enamels. For maximum protection, topcoat with a Rust-Oleum Stops Rust Enamel. If using an auto lacquer, a test application for compatibility is recommended. Automobile Primer is fast drying and sandable for bare or lightly rusted surfaces. Not for use on galvanized steel.
Stops Rust with Custom Spray 5-in-1 allows you to choose between 5 different spray patterns for ultimate control and confidence over your next project.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
Remove all dirt, grease, oil, salt, and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
APPLICATION
Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Before spraying, turn dial to the desired spray pattern and test on an inconspicuous area or on scrap material. Scan QR code to learn more. Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Keep the can the same distance from the surface. Recommended distance from the surface will vary based on spray selection. Scan QR code on can for details. Keep the can in motion while spraying. Spray in a steady back-and-forth motion, slightly overlapping each stroke. Spray at any angle. Apply 2 or more light coats a few minutes apart. Turn dial to LOCK position when finished spraying.
Dial Position Spray Description Recommended Spray Distance
1 High Output 10-14”
2 Standard 8-12”
3 Low Output 3-6”
4 Vertical Fan 8-12”
5 Horizontal Fan 8-12”
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 15-30 minutes, to handle in 1-2 hours and fully dry in 48 hours. Apply a topcoat or recoat within 1 hour or after 48 hours. Wait 4 hours before dry sanding.
DIAL CARE AND CLOGGING
To prevent clogging, clean face of the dial with mineral spirits when finished spraying. DO NOT remove cap or dial.
CLEAN UP
To remove wet paint, clean with mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor.