DESCRIPTION AND USE
Rust-Oleum Stops Rust Anti-Slip creates a non-skid surface on concrete, metal and wood. The fast drying formula dries clear and can be applied to ramps, stairs, railings and more.
Stops Rust Anti-Slip features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PRODUCT APPLICATION
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90 °F (10- 32 °C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200 °F (93 °C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and let dry. Remove loose paint and rust with a wire brush or sandpaper. Clean concrete surfaces with a suitable cleaner and water. Rinse and allow to dry. Lightly sand glossy surfaces.
PRIMING
Priming is not necessary but additional coats may be required on porous surfaces such as unfinished wood and concrete.
APPLICATION
Shake the can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70 °F (21 °C) and 50% relative humidity. Allow more time at cooler temperatures. Apply a second coat within 1 hour or after 48 hours. Allow surfaces to dry for 24 hours before use.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off the spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.