DESCRIPTION AND USES
Rust-Oleum Stops Rust Aluminum Primer is a specially formulated base coat for aluminum or galvanized metal. This primer can be used with a variety of topcoats including oil-based enamels, latex enamels and aerosols. This latex primer cleans up easily with soap and water and dries quickly.
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent or other suitable cleaning method. Rinse thoroughly with fresh water and allow to fully dry. All surfaces must be dry at time of application. Scrape and wire brush or power tool clean to remove loose rust, scale and deteriorated previous coatings.
APPLICATION
Apply only when air and surface temperatures are between 50-100°F (10-38°C) and humidity is below 85% to ensure proper drying. Before using, stir thoroughly to ensure any settled pigment is re-dispersed. Thinning is not required. However, in hot, dry conditions, you may thin up to ½ pint with fresh water per gallon to extend to workable brushing time.
Use a good quality brush. Avoid excessive brushing as this will reduce film thickness and protection. Use light even brush strokes to ensure proper coverage and the smoothest finish. Use a good quality synthetic roller. Cover approximately one square yard at a time. Roll away from previously coated area and work back to it for a uniform appearance.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 1-2 hours, to handle in 2-4 and can be recoated after 1-3 hours. Topcoat with a brush on latex or brush on oil based enamel in 1-2 hours and an aerosol in 16-24 hours.
CLEAN-UP
Clean brush, roller, and other and tools with soap and water.