DESCRIPTION AND USE
Rust-Oleum Stops Rust Cold Galvanizing Spray provides maximum corrosion resistance through galvanic protection. Use for touch-up and repair to damaged galvanized steel, galvanized ducts, fences, gutters, trucks, trailers, and more. Do not topcoat with an alkyd finish. Cold Galvanizing Spray contain 93% zinc in the dry film.
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper.
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50-90 °F (10-32 °C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200 °F (93 °C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake the can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70 °F and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 15 minutes, to handle in 1-2 hours and fully dry in 24 hours. Recoat within 1 hour or after 24 hours. If a topcoat is desired, use a latex coating.
CLEAN-UP
Clean valve immediately after use by turning can upside down and depressing spray button for 3-5 seconds. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off the spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.