DESCRIPTION AND USES
Varathane One Step Stain & Polyurethane (Oil-Based) allows the user to both stain and protect their wood surfaces in one easy application. This innovative, oil-based formula provides deep, rich color and polyurethane finish in one easy step. By combining a stain with polyurethane, the need for multiple product application is eliminated and wood surfaces are enriched with a deep, rich beautiful color and protected by long lasting polyurethane. Use on all interior projects including: intricate moldings, wood furniture, trim, cabinets, doors and paneling.
Available in eight distinct colors, Varathane One-Step Stain & Polyurethane offers an easy and convenient alternative to the traditional method of staining and protecting.
RECOMMENDED COMPANION PRODUCTS
Varathane Premium Sanding Sealer seals wood’s pores and is easy to sand. It is available in quarts and gallons.
Varathane Wood Conditioner is an essential step to ensure a uniform finish on soft woods that have an uneven grain structure like pine, fir, alder, and birch. It is available in half-pints, quarts and gallons.
PRODUCT APPLICATION
SURFACE PREPARATION
Bare or Unfinished Wood - Remove any existing finishes with sandpaper or stripper. Prepare bare wood for product application by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress through #150, #180 and #220 grits. Before staining, remove all sanding dust, dirt, grease or glue with a vacuum or clean rag dampened with mineral spirits.
Wood with Existing Polyurethane Finish – Lightly sand existing finish with #320 grit sandpaper to encourage adhesion. Remove all dust with a vacuum or clean lint-free rag.
TESTING COLOR
Be sure to test Varathane One-Step Stain & Polyurethane to verify the desired color. To test, apply in an inconspicuous area. For a deeper color, additional coats may be applied.
APPLICATION
Stir the contents thoroughly before use. Do not shake. Use adequate ventilation at all times. Apply only when air (ambient) temperature is between 55-90°F (13-32°C) and the relative humidity is below 85%. Apply using a good quality, natural bristle brush or applicator, brush in the direction of the grain until a uniform film has been achieved. To prevent brush marks, avoid excessive brushing. Additional coats can be applied with one hour dry time between coats. Lightly sand between coats with #320 grit sandpaper. Remove all sanding dust before applying additional coats.
CLEAN-UP
Clean application tools and equipment with mineral spirits or paint thinner. Dispose of unused contents in accordance with local, state and federal regulations.