DESCRIPTION AND USES
Varathane Ultra Thick Floor Finish is designed to offer a thicker, stronger and faster project completion than a traditional polyurethane floor finish. The advanced self-leveling technology allows floor finish projects to be completed in only 2 coats instead of the traditional 3-4 coats. This water-based formula provides excellent scuff, scratch and stain resistance with the convenience of soap and water clean-up. It is suitable for use on all interior bare or stained hardwood floors and surfaces including furniture, doors, trim and more.
This product is not recommended for linoleum, vinyl or glazed tiles, metal or exterior surfaces.
PRODUCT APPLICATION
SURFACE PREPARATION
PREVIOUSLY FINISHED SURFACES – For best adhesion, surfaces must be clean, dry and completely free of wax, grease, oil, shellac, lacquer, mildew and polishes. Waxes must be removed with a wax stripper. Sanding does not remove wax. Shellac must be removed with a paint stripper. Previously finished floors in good condition should be cleaned with a T.S.P. (Tri Sodium Phosphate) solution in water and wiped thoroughly with clean water. DO NOT use T.S.P. on bare wood floors as discoloring will occur. Some types of prefinished or factory finished floors may not be compatible with Varathane Ultra Thick Floor Finish.
Old finishes in poor condition must be removed. Use the Varathane ezV® floor sander to obtain a smooth surface. Do not use steel wool as rust may develop after the finish has been applied. Remove all sanding dust using a vacuum or cloth dampened with mineral spirits.
Warning: Sanding dust can be a spontaneous combustion hazard. Always dispose of collected sanding dust immediately.
UNFINISHED BARE WOOD – Use the Varathane ezV sander to sand the new wood surface. Remove sanding dust with a vacuum and a rag dampened with mineral spirits. Refer to the Varathane Floor Finishing brochure for more information.
STAINED OR PAINTED WOOD
Follow manufacturer’s directions for application of stain or paint. Make certain surface is thoroughly dry before applying Varathane Ultra Thick Floor Finish. Refer to the manufacturer’s label for dry times. For best results, use Varathane premium Wood Stains.
APPLICATION TIPS
Product appears milky when wet but dries to a crystal clear coating. Use adequate ventilation at all times. Do not apply in direct sunlight. Apply at temperatures above 55°F (13°C) and below 90°F (32°C) and relative humidity below 85%. To prevent bubbles in the finish, DO NOT shake the container, over-brush or over apply the finish. Test Varathane Ultra Thick Floor Finish in an inconspicuous area before beginning. Testing is particularly important when applying over paints or stains as the appearance of these products may change when a water-based finish is applied.
APPLICATION
Stir thoroughly before and during use. To prevent bubbles in the finish, DO NOT SHAKE. Apply using a high quality synthetic bristle brush, T-bar or shed-free applicator pad. DO NOT USE A ROLLER OR LAMBS WOOL APPLICATOR PAD. Two coats are REQUIRED. Allow the first coat to dry a minimum of 3-5 hours, but less than 3 days. Recoat only when the previous coat has dried clear and feels hard. If any coat has dried more than 3 days, lightly sand with 220 grit sandpaper before recoating. (A powder should develop when lightly sanded). If necessary, apply additional coats following the directions above. Note: Uneven or inadequate film build will result in an inconsistent appearance, orange peel or stipple.
DRY TIME
Dry times are based on 70°F and 50% relative humidity. Lower temperatures and/or higher humidity may cause slower dry times. Allow the finish to dry 24 hours before light traffic and 7 days for full cure.
CLEAN UP
Soap and Water