DESCRIPTION AND USES
Varathane Whitewash Wood Enhancer can create a fresh and vintage look on furniture and more. It contains an innovative oil based formula that adds beauty and brightens wood with a shade of white color while allowing the natural grain to show through. Can be applied to bare wood or over a wood stain after it's dried. No wood conditioner required. Varathane Whitewash can be used on all interior wood projects such as furniture, cabinets, doors, and trim.
Not for use on outdoor surfaces. For wood substrates only.
PRODUCT APPLICATION
SURFACE PREPARATION
Remove any existing finishes with sandpaper or paint stripper. Prepare bare wood for staining by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress though #150, #180 and #220 grits. Before staining, remove all sanding dust and dirt with a vacuum and grease or glue with a clean rag dampened with mineral spirits.
TESTING COLOR
Be sure to test your stain to verify the desired color. To test, apply the stain in an inconspicuous area.
APPLICATION
When using more than one can, pour all contents together in a separate container and mix well to ensure uniformity. Stir or shake material thoroughly before and occasionally during use. For best results, use at a temperature between 60°F and 90°F. 1 hour dry time. Allow longer dry time on damp, humid days.
For a uniform coating of Whitewash over bare or stained wood: Apply liberally with a brush or clean lint-free rag. Allow to penetrate for 2-3 minutes then remove excess to ensure proper dry time and adhesion of topcoat by wiping with a rag in the direction of the grain. Longer penetration times will lead to more opaque layer of Whitewash. After 1 hour an additional coat can be applied to build to desired opacity.
For a distressed dry brush look over bare or stained wood: Dip the tip of a dry bristle brush into the Whitewash, dab on a cloth until semi-dry, then use light, feathery strokes in the direction of the wood grain. Allow to dry 1 hour.
For a vintage Whitewash layer over paint or stain: Once stain or paint is completely dry, lightly sand entire piece using #220 grit sandpaper. Remove dust. Cover entire surface area with Whitewash and allow to penetrate for 30 seconds. Wipe away to desired effect. Allow to dry for 1 hour.
PROTECTING THE WOOD
To complete your wood project and for the best protection, finish with any water-based Varathane Polyurethane depending on your project needs. Polyurethane can be applied 1 hour after application.
NOTE: Oil based polyurethanes add an amber hue to the finish.
COVERAGE
Up to 275 square feet per quart.
CLEAN UP
Clean application tools and equipment with mineral spirits.
DISPOSAL
Warning! Rags, brushes, or other waste soaked with this product may spontaneously catch fire if improperly discarded. Immediately after use, place rags or waste in a sealed, waterfilled metal container. Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations.