DESCRIPTION AND USES
Rust-Oleum Specialty Marking Sprays marks the spot in a variety of bright, visible colors. These sprays temporarily adhere to grass, gravel, soil, lumber, concrete, and blacktop and withstand general weathering. The convenient spray through cap makes these sprays ideal for many outdoor uses such as marking athletic fields, roadways, landscaping areas, work areas, and more.
PRODUCT APPLICATION
SURFACE PREPARATION
ALL SURFACES: Remove loose contaminants by sweeping the surface before application of the coating.
PAINTING CONDITIONS
Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Invert can and point at ground or floor. Hold can 4-8" from surface to be marked. Press tip sideways to spray paint. Spray using a steady, even stroke to prevent build-up. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 15 minutes and is fully dry in 8 hours. May recoat at any time.
CLEAN-UP
Clean valve by spraying upright for 2-3 seconds after each use. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.