DESCRIPTION AND USES
Rust-Oleum Specialty Mirror Effect is an innovative coating that transforms glass and acrylic glass into a unique mirror finish. Ideal for glass vases, candleholders, framed glass, jars and tabletops.
Apply to the reverse or opposite side of glass. For use on interior surfaces only.
PRODUCT APPLICATION
SURFACE PREPARATION
Remove water spots and other imperfections on substrate to achieve optimal results. Clean glass thoroughly with glass cleaner or soap and water, using a lint-free cloth. Allow glass to dry completely before painting. Coating will not hide imperfections on substrate.
PAINTING CONDITIONS
Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is between 50ºF (10ºC) and 90ºF (32ºC) and humidity is below 65% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
APPLICATION
Shake can vigorously for one minute after mixing ball begins to rattle. Shake often during use. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Make sure to apply paint to the reverse or opposite side of glass that will be displayed. Hold can upright 10-12" from surface and spray in a steady back-and-forth motion. Apply using very thin coats, allowing the paint to dry for 1 minute between coats. Apply up to 5 coats to achieve the desired mirror effect. Paint will rapidly change in appearance and mirror effect will appear while coating dries. The painted side will appear dull, with the reverse side showing the mirror finish. Apply a thin coat of any Rust-Oleum Matte Clear spray for extra protection.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries completely in 5-10 minutes. May recoat at anytime.
CLEAN-UP
Wipe off tip before storing. Clean up wet paint with xylol or mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening