DESCRIPTION AND USES
Rust-Oleum Professional DTM Alkyd Enamels are oil modified alkyds with excellent rust prevention when applied directly to metal. They also offer excellent coverage, chip resistance and color retention. Not for use on galvanized steel.
PRODUCT APPLICATION
SURFACE PREPARATION
Clean surface with soap and water, rinse and let dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
APPLICATION
Apply only when air and surface temperatures are between 32-90ºF (0-38ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200ºF (93ºC) or galvanized metal. Professional DTM Alkyd Enamels can be used over most latex or oil paints. Professional DTM Alkyd Enamels and Primers are not recommended for water immersion.
Mix thoroughly to ensure any settled pigment is re-dispersed before using. Thin material, only if necessary, with acetone. For brush or roller, thinning is not normally required. For air spray, thin up to 1-½ to 2 pints per gallon. Do not thin with gasoline, lacquer thinner, turpentine, etc. For airless spray, thinning is not normally required. Apply with a good quality brush, roller, or spray gun.
Brush: Use light, even strokes Excessive brushing reduces film thickness and protection.
Roller: The rougher the surface, the longer the roller nap should be. Cover approximately one square yard at a time. Roll away from previously coated area and work back on it for a uniform appearance. Use a brush on crevices and sharp edges.
Spray Gun: Follow spray gun directions carefully. Always keep the gun ten to twelve inches from the surface and in motion while spraying.
CLEAN-UP
Clean brush, roller, and other tools with mineral spirits.