DESCRIPTION AND USES
Rust-Oleum Professional 2X Distance Marking Paint Sprays are an aerosol coating packaged for use in an inverted position as a marking paint. Use for marking construction and excavation sites, underground utilities and for traffic safety. This product is not water-soluble and withstands general weathering. These sprays are recommended for use with Rust-Oleum® #2393000 Marking Wand and feature fast dry and adhesion to concrete, blacktop, gravel, soil and grass.
APPEARANCE
Flat to semi-gloss finish (dependent on surface porosity).
PACKAGING
15-ounce containers, 6 containers/carton
PRODUCT APPLICATION
SURFACE PREPARATION
Remove excessive loose debris from the surface before application of the coating.
APPLICATION
Apply when temperature is above 40°F (4°C) and humidity is below 85% to ensure proper drying. Protect surrounding surfaces from overspray. Overspray can carry a significant distance.
Shake can vigorously for one minute after mixing ball is heard. Invert can and point at ground or floor. Hold can 4 to 10 inches above surface to be marked. Press in sideways to spray or use Rust-Oleum Marking Wand (#2393000). Follow directions for proper use of this equipment. Keep can in motion to prevent build-up.
DRY & RECOAT
Dry and recoat times are based on 70-80°F and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 15 minutes and is fully dry in 8 hours.
CLEANUP
When finished spraying, clear spray valve by turning can upright and pushing spray button for 2-3 seconds. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve.