DESCRIPTION AND USES
Rust-Oleum Professional Galvanizing Sprays contain a high loading of zinc used to touch-up damaged or weathered galvanized surfaces such as gutters and fences. The Bright Galvanizing Compound allows you to match newer galvanized surfaces, while the Cold Galvanizing Compound repairs more weathered surfaces.
7584 contains 80% zinc and 12% aluminum in the dry film.
7585 contains 93% zinc in the dry film.
RECOMMENDED TOPCOATS
No top coat is necessary but if one is desired, use a water based product. If an oil-based (alkyd) product is the desired finish, use a water-based primer as an intermediate coat.
PRODUCT APPLICATION
SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with commercial detergent or other suitable cleaner. Rinse thoroughly with fresh water and allow to fully dry.
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Apply only when air and surface temperatures are between 50-90°F (10-32°C) and relative humidity is below 85% to ensure proper drying. Use in a well ventilated area. Protect surrounding area, clothing and skin from overspray. Overspray can carry a significant distance. Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 12-16 inches from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid drips and runs.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 30 minutes, to handle in 1-2 hours and fully dry in 24 hours. It can be recoated within 1 hour or after 24 hours.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or mineral spirits.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick a pin or other object into the stem. Properly discard empty container. Do not burn or place in home trash compactor.