DESCRIPTION AND USES
Rust-Oleum Turbo Spray System delivers the trusted protection of Stops Rust 4X faster than traditional aerosol cans. Up to 10" wide fan spray covers the surface in fewer passes for faster project completion. The Turbo Spray System lets you achieve professional results without using spray equipment or solvents for cleanup. Projects this big require a lot of paint, so the Turbo Spray System offers an extra tall can filled with 24 ounces of Stops Rust Protective Enamel. Get your to do list done in minutes with this fast, fun, new application system.
Rust-Oleum® Stops Rust® Universal Bonding Primer is a fast dry, maximum adhesion primer that firmly bonds any topcoat to difficult-to-paint surfaces, including two part epoxies. It may be used on interior or exterior surfaces to include galvanized steel, wrought iron railings, furniture, aluminum flashings, PVC, porcelain, masonry, glazed brick, metal, wood, fiberglass and other surfaces.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and let dry. Remove all oil, grease, wax and petroleum based materials with mineral spirits. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from surface and spray in a steady back-and forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 30 minutes and dries to handle in 1 hour. Apply a second coat or topcoat at anytime. For two part epoxies, wait two hours before top coating.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.