DESCRIPTION AND USES
Rust-Oleum Transformations Protective Topcoat is designed to provide the perfect finishing touch to any Cabinet Transformations Cabinet & Trim Coating project. Transformations Protective Topcoat is formulated to provide excellent protection from scratches and stains. It is ideal for interior projects such as interior painted surfaces, or stained and bare wood surfaces including furniture, doors, windows, cabinets and trim. It is crystal clear, odorless and provides for easy water clean-up. It is not recommended for linoleum, vinyl or glazed tiles and metal.
PRODUCT APPLICATION
SURFACE PREPARATION
STAINED OR PAINTED WOOD - Follow manufacturer’s directions for application of stain or paint. Make certain the surface is thoroughly dry before applying Transformations Protective Topcoat. For best results, use Transformations Basics Cabinet and Trim Paint or Transformations Decorative Glaze.
PREVIOUSLY FINISHED SURFACES – To ensure proper adhesion, surfaces must be clean, dry and free of wax, grease, oil, shellac, lacquer, mildew and polishes. Remove wax with a wax stripper, shellac with a paint stripper, and mildew with a solution of up to 10% household bleach and water. Old finishes in poor condition must be removed by sanding using 120-150 grit sandpaper. Sand to obtain a smooth surface. Do not use steel wool as rust may develop after the finish is applied. Remove all sanding dust using a vacuum or cloth dampened with mineral spirits.
UNFINISHED SURFACE PREPARATION - Sand smooth using 120–150 grit sandpaper and remove all sanding dust with a vacuum or cloth dampened with mineral spirits. If a filler or putty is used, make sure that it does not contain wax and allow enough time for it to dry thoroughly.
APPLICATION
Product appears milky when wet but dries to a crystal clear finish. Use adequate ventilation at all times. Do not apply in direct sunlight. Apply only when air (ambient) temperature is between 55-90°F (13-32°C) and the relative humidity is below 85%. Be careful when applying over white or pastel paints or stains as discoloration may occur. Test in an inconspicuous area before beginning. Testing is important when applying over paints or stains as the appearance of these products may change slightly when a water-based finish is applied.
Stir thoroughly before and during use. To prevent bubbles, DO NOT SHAKE. Apply using a good quality, synthetic bristle brush, foam brush, or applicator. Do not apply with a roller. It is critical to avoid overbrushing. For best appearance, brush in long sections in the direction of the grain or previous brush marks. Apply an even, light coat to all surfaces. Allow the finish to dry a minimum of 2 hours and then re-coat. Lower temperatures and/or higher humidity may cause slower dry times. Recoat only when previous coats have dried clear and feel hard (no longer tacky to touch). A powder should develop when lightly sanded. If any coat has dried more than 24 hours, sand lightly before re-coating to avoid brush marks. A minimum of 3 coats are recommended. If grain raise occurs, sand smooth before final coat. Allow finish to dry 24 hours before light use and before installing cabinet doors – keep drawers and doors ajar until completely dry. Wait 3 days before subjecting surface to normal usage. Avoid using cleaners on coated surfaces for a minimum of 7 days. Dispose of any unused material properly.
COVERAGE
100-125 sq. ft. per qt.
CLEANUP
Soap and water.