DESCRIPTION AND USES
Rust-Oleum Automotive BBQ & Stove is a durable protective enamel that renews and protects surfaces subject to intermittent heat up to 1200°F (648°C). This rust preventive formula is suitable for the exterior of barbecue grills, wood stoves, radiators, fire pits, fireplace screens, automotive parts, and more. BBQ & Stove features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PRODUCT APPLICATION
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 85% to ensure proper drying. Priming is not recommended. Do not use on metal directly exposed to open flame or in direct contact with food, such as a grill grate. Avoid application in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply two or more light coats a few minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 30 minutes and to handle in 1-2 hours. Allow paint to dry for 1 hour before heating. Product may emit smoke and a harmless odor May recoat within 1 hour or after 48 hours.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.