READ ENTIRE LABEL BEFORE APPLYING
Description and Use
Rust-Oleum Automotive Camouflage Spray is designed to provide a non-reflective finish for hunting and sporting equipment. Various colors can be combined in a variety of patterns to blend with any terrain. Camouflage is suitable for use on vehicles, tree stands, decoys, blinds, boats and equipment. To mimic real life patterns, apply to leaves and twigs as stencils. Apply a base coat of color. Place the leaves and twigs randomly over the object to be painted. Spray over the items using three or four colors. Camouflage enamel features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
Note: Items painted with Camouflage should not be immersed in water for extended periods of time.
Painting Conditions
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Surface Preparation
Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Use of a Rust-Oleum primer provides added corrosion protection, enhances adhesion and hiding, and is especially recommended for metal and wood surfaces. Recommended primers include 7769830 Rusty Metal Primer and 7780830 Clean Metal Primer.
Application
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-12" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
Dry & Recoat
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 20 minutes, to handle in 1 hour and is fully dry in 24 hours. Apply a second coat or topcoat within 1 hour or after 24 hours.
Clean-Up
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
Clogging
If the valve clogs, twist and pull off the spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into the can's valve opening.