DESCRIPTION AND USES
Rust-Oleum Automotive Universal Bonding Primer is a fast dry, maximum adhesion white primer that firmly bonds any topcoat to difficult-to-paint surfaces, including two part epoxies. It may be used on interior or exterior surfaces to include galvanized steel, wrought iron railings, furniture, aluminum flashings, PVC, porcelain, masonry, glazed brick, metal, wood, fiberglass and other surfaces.
Universal Bonding Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PRODUCT APPLICATION
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and let dry. Remove all oil, grease, wax and petroleum based materials with mineral spirits. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist. Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum.
Shake often during use. Hold can upright 10-16" from surface and spray in a steady back and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Apply multiple coats versus applying one heavy coat. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 30 minutes and dries to handle in 1 hour. Apply a second coat or topcoat at anytime. For two part epoxies, wait two hours before top coating.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.