DESCRIPTION AND USES
Rust-Oleum High Performance Wheel enhances the look and color of automobile wheels and helps prevent the formation of rust. It is suitable for use on plastic hubcaps and wheels made of aluminum or steel. High Performance Wheel features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Thoroughly wipe down the wheel surface with Rust-Oleum Wax & Tar Remover. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand smooth and glossy surfaces. For best results, use Rust-Oleum Adhesion Promoter or sand surface with #1000 grit sandpaper.
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. For best appearance, apply one light coat followed by one wet coat. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 10 minutes and is fully dry in 30 minutes. To improve the finish gloss, apply a topcoat of High performance Wheel Clear after 10 minutes.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.