DESCRIPTION AND USES
Rust-Oleum Automotive Marking Paint is designed to mark the spot in a bright, visible color. It temporarily adheres to grass, gravel, soil, lumber, concrete and asphalt surfaces and withstands general weathering. It has a convenient spray-thru cap suitable for many outdoor uses such as marking athletic fields, roadways, landscaping areas, work areas and more.
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING PROJECT
APPLICATION
Use when temperature is between 40-90°F (4-32°C) and humidity is below 85% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Invert can and point at ground or floor. Hold can 4-8” above the surface to be marked. Press tip sideways to spray paint. Spray using a steady, even stroke to prevent build-up. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 15 minutes and is fully dry in 8 hours.
CLEAN-UP
Clean valve by spraying upright for 2-3 seconds after each use. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, carefully remove the spray tip and clean in thinner. Do not insert any object into can valve opening.