DESCRIPTION AND USES
Rust-Oleum Metallic Bright Reflective Finish is designed to produce a bright, shiny and distinctive finish. This metallic paint is recommended for interior automotive accessories and including helmets, bikes, and more. The Bright Reflective finish features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
Metallic Bright Reflective Finish is not rub-resistant. It is also not resistant to outdoor conditions. For interior use only.
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, and wax with Rust-Oleum Wax & Tar Remover. Clean the surface with soap and water or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth.
PRIMING
Use of a Rust-Oleum Primer provides added corrosion protection on metal and promotes adhesion and hiding. A primer is especially recommended for metal and plastic surfaces. Recommended primers include 249321 Primer Sealer and any of the sandable primers (249419 Red, 252472 Light Gray, or 249415 Gray).
APPLICATION
Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50 and 90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16” from surface and spray in a steady backand-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 10 minutes and is fully dry in 30 minutes. Apply a second coat if necessary at any time. Do not apply a clear topcoat.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.