DESCRIPTION AND USES
RockSolid Composite Deck Refresh is an exceptional water-base exterior stain and sealer designed to refresh the color and restore the finish on faded composite wood decks. It provides protection against water damage, UV graying and mildew. It is easy to use, dries fast and cleans up quickly with water.
Use on wood capped composite decks. Follow specific manufacturer’s recommendation before applying to any composite decking. Not recommended for plastic capped composite decks. Be sure to choose the tone that best matches the original composite deck color. (Deck Refresh is not recommended for color changes). Final color will be dependent on age, type and condition of the deck.
PRODUCT FEATURES
One coat application
Protects against UV damage
Resists mold & mildew growth
Provides superior water repellency with NeverWet ® properties
Covers up to 300 square feet
3 Year Performance Guarantee
SURFACE PREPARATION
Failure to follow this preparation method may result in poor adhesion and possible coating failure. If the composite deck has previously applied coatings such as paint, stain or sealer remove/strip prior to starting. Check the composite deck for loose or extremely damaged boards and make necessary repairs prior to starting the project.
Clean the composite deck surface with RockSolid Composite Deck Cleaner or RockSolid Deck & Patio Cleaner and treat any deep stains with RockSolid Composite Deck Stain Remover. After cleaning allow the deck surface to completely dry, then conduct a splash test on the composite deck to confirm water absorption before applying this product. To conduct the test, splash a few drops of water on multiple areas of the composite deck and watch for water absorption. If the water is not absorbed within a few minutes, a barrier exists, and should be removed before staining can begin. Make sure the entire composite wood surface is dry and free of dust, dirt and debris. Cover all surrounding areas not intended to be coated.
APPLICATION
DO NOT APPLY IF RAIN IS EXPECTED WITHIN 24 HOURS OF APPLICATION. Apply when surface and air temperature is between 50-90ºF and humidity is below 65% and will remain between 50-90ºF for at least 6 hours after application.
NOTE: Test RockSolid Composite Deck Refresh in an inconspicuous area first.
Thoroughly stir the material before and during application. When using more than one container, combine all containers to ensure color consistency. Using either a 3/8” nap roller, short nap stain pad, synthetic paint brush or a pump-style sprayer saturate and apply generously in a consistent pattern. If using a pump-style sprayer back brushing with a synthetic paint brush is recommended. Work to a wet edge at all times. Avoid rolling back into coated areas where drying has begun. To minimize lapping, always work from end to end on a few boards at a time, and maintain a wet edge. On horizontal surfaces, coat board ends and all 4 sides whenever possible to protect against moisture absorption. Clean up drips or spatters with water IMMEDIATELY, as dried coating is very difficult to remove.
Allow to dry 24 hours before light foot traffic and 48 hours before replacing furniture. If surface is tacky or soft, extend drying time before putting heavy objects back in place. Full cure to a hard finish will take approximately 7 days. Avoid dragging furniture across surface. On newly coated surfaces, allow 7 days for coating to cure before washing.
CLEAN UP
Use mild soap and water to remove drips and spatters as soon as possible.